What you need
-
Step 1 Check for OBD2 codes, ABS, DTC without a scanner
-
Turn ignition two clicks to the ON position
-
Insert a bent paperclip into the SCC connector. (See video for where the SCC connector is located)
-
Touch both of the exposed pins to short the connection. Continue to short the connection for more than 5 seconds.
-
Any codes will display on the Odometer/Trip display, or "NO" if there are no stored codes
-
Remove paperclip and wait 10 seconds
-
Turn ignition OFF and remove key
See AlsoHow to read OBD codes -
-
Almost done!
Finish Line
Cancel: I did not complete this guide.
Author
with 1 other contributor